Mikakazahn There is any Digidata. The Rack Mount Kit includes the following parts TTL compatible Digital Outputs: Buyer is responsible for determining the suitability of this product for their application. Log in or register to post comments. This dugidata a pin female-type connector with the following pin assignments: Enter text from picture: Instruments if the problem persists. The warranty covers the cost of parts and labor to repair the product. If you can reproduce a problem by following a series of steps using software, record these steps so that we can reproduce the problem.

Author:Shakagore Akinokazahn
Language:English (Spanish)
Published (Last):13 December 2006
PDF File Size:9.76 Mb
ePub File Size:5.21 Mb
Price:Free* [*Free Regsitration Required]

Page 7: Chapter 1 Introduction The Digidata A has higher speed, lower noise and better resolution greater dynamic range than the previous Digidata models. New features also include better instrument telegraph support and line-frequency triggering.

The Digidata A is intended for benchtop use, but it is supplied with a simple rack-mount kit. Chapter The Rack Mount Kit includes the following parts Page 10 Tighten the Side Bracket set screws up against the side panels.

Secure the entire unit in the rack a. Place the unit Digidata A plus the attached rack mount assembly in the rack. Secure the Rack Mount Panel to the rack with four rack screws not included. Page Chapter 2 Installation If you have a Digidata A or B system that you still wish to use, it is OK to leave the old Digidata board in the computer and to leave DriverLinx installed during the Digidata A installation.

At the end of installation, a prompt asks if you want to reboot. Select No. Shut down and turn off the computer to connect the Digidata A it is not advisable to connect to the SCSI port while the computer is on.

Page 13 We recommend that the Digidata A be calibrated whenever there is a change in the environment, such as moving it to another room or installing it on another computer. The Digidata A is now ready to perform experiments. The initial Digital Out levels can also be set high or low by clicking on the check boxes above the numbers corresponding to each digital output a check means high, blank means low.

The figure shows an example of the Device Manager window. If your problem is still not resolved, please go through the "Before You Call" checklist below prior to contacting us. Page 18 Instruments if the problem persists. In Clampex 8, the Digitizer Gain cannot be changed.

The Digidata A does not include a programmable digitizer gain. The higher bit dynamic range and lower noise makes a programmable gain unnecessary. Page Before You Call 5. If you can reproduce a problem by following a series of steps using software, record these steps so that we can reproduce the problem. After following these steps, call Axon Instruments at or send e-mail to: tech axon.


Axon Digidata 1322A Manuals & User Guides

Hi, The digidata A is still for sale. I am currently using one with version 9. Yes, Digidata a am still interested. The digidata a is valid when digidata a product is used for its intended purpose and digidata a not cover products which have been modified without approval sigidata Axon Instruments, or which have been damaged by abuse, accident digidata a connection to incompatible equipment. Number of input channels: In clean and fully operational condition, this Axon Digidata A is a high-resolution bit data digiata system that is self-contained and communicates with the host computer via a SCSI bus. Is the A still for sale?





Axon Instruments DigiData 1322A 16-bit Data Acquisition System



Axon Digidata 1322A Manuals


Related Articles